# Flightlab Ground School 2. Two-Dimensional Aerodynamics ......

date post

30-Jan-2020Category

## Documents

view

0download

0

Embed Size (px)

### Transcript of Flightlab Ground School 2. Two-Dimensional Aerodynamics ......

Bill Crawford: WWW.FLIGHTLAB.NET 2.1

Flightlab Ground School 2. Two-Dimensional Aerodynamics

Copyright Flight Emergency & Advanced Maneuvers Training, Inc. dba Flightlab, 2009. All rights reserved. For Training Purposes Only

Our Plan for Stall Demonstrations

We’ll do a stall series at the beginning of our first flight, and tuft the trainer’s wing with yarn before we go. The tufts show complex airflow and are truly fun to watch. You’ll first see the tufts near the root trailing edge begin to wiggle and then actually reverse direction as the adverse pressure gradient grows and the boundary layer separates from the wing. The disturbance will work its way up the chord. You’ll also see the movement of the tufts spread toward the wingtips. This spanwise movement can be modified in a number of ways, but depends primarily on planform (wing shape as seen from above). Spanwise characteristics have important implications for lateral control at high angles of attack, and thus for recovery from unusual attitudes entered from stalls. Our rectangular- planform trainers have excellent stall characteristics. Other planforms may need to be cajoled into behaving as if they were rectangular, stalling first at the root while the ailerons keep flying.

We’ll first examine two-dimensional airfoil sections, then three-dimensional wing planforms. We’ll only spend a few minutes during our flights watching the wing tufts, but those minutes can be full of information.

Remember Mass Flow?

Remember the illustration of the venturi from your student pilot days (like Figure 1)? The major idea is that the flow in the venturi increases in velocity as it passes through the narrows.

The Law of Conservation of Mass operates here: The mass you send into the venturi over a given unit of time has to equal the mass that comes out over the same time (mass can’t be destroyed). This can only happen if the velocity increases when the cross section decreases. The velocity is in fact inversely proportional to the cross section area. So if you reduce the cross section area of the narrowest part of the venturi to half that of the opening, for example, the velocity must double at that point.

For a fluid (like air), the density, ρ, times the cross section area, A, of the venturi times the velocity, V, equals the mass airflow. Mass airflow, in and out, remains constant, so:

ρAV = Constant

The above is known as the continuity equation.

Density (denoted by the Greek letter ρ, pronounced “roh”) is the mass of air (in slugs) per volume (one cubic foot). Air is considered incompressible at the low, subsonic speeds we fly our trainers—so density doesn’t change for us, only velocity.

Figure 1 Velocity in a Venturi

Arrow length indicates velocity. Velocity actually starts rising before air enters the venturi.

(ρAV)A = (ρAV)B = (ρAV)C = constant

A B C

Two-Dimensional Aerodynamics

Bill Crawford: WWW.FLIGHTLAB.NET2.2

Remember Bernoulli?

Bernoulli’s Theorem deals with conservation of energy. It tells us that for an ideal fluid (incompressible and frictionless) the total energy of the flow in the venturi remains constant. If we convert the total energy per unit volume of mass times flow rate into pressures, the sum of the static pressure and the dynamic pressure will equal a constant total pressure. Static pressure is the ambient pressure exerted by a column of fluid at a given level. Dynamic pressure is the pressure exerted by a mass of fluid in motion. In the formula below, static pressure is PS. Dynamic pressure is 1/2 ρV2, or one-half the density, ρ, of the fluid times its velocity, in feet-per-second, squared. PT is the total pressure:

PS + 1/2 ρV2 = Constant PT

Or in English:

Static pressure + Dynamic pressure = Constant Total Pressure

So if velocity and thus dynamic pressure increases, static pressure will decrease. In the venturi in Figure 2, the increase in dynamic pressure with velocity produces a decrease in static pressure as the tube narrows. The static pressure then rises again as the tube widens downstream and the airflow slows down.

Of course, air isn’t an ideal fluid: It’s compressible and viscous. Compressibility

obviously becomes important approaching the speed of sound, but for present purposes can be ignored. But we won’t ignore viscosity for long, because the nature of the airflow within the boundary layer over a wing depends on friction.

After looking at the behavior of velocity and pressure in a venturi, it’s tempting to declare that the reason airflow accelerates over the top of a wing, and static pressure consequently decreases, is that a wing is just one half of a venturi, with the mass of the atmosphere playing a roll equivalent to the other half. That’s a valid way of thinking about it, and easy to visualize. But aerodynamics is a subject in which alternative visualizations exist side-by-side. A different but not necessarily contradictory understanding of the acceleration of flow has to do with the idea of circulation. Circulation in turn gives us a way of visualizing the generation of wingtip vortices, and understanding how the strength of the vortical flow relates to the particular conditions under which the wing was producing lift. We’ll return to this farther on.

Figure 2 Pressure Decreases as Velocity Increases

Longer arrows indicate greater pressure drop relative to the freestream.

Pressure rise

Two-Dimensional Aerodynamics

Bill Crawford: WWW.FLIGHTLAB.NET 2.3

Streamlines

An airfoil section is equivalent to a hypothetical wing of infinite span (therefore no tips) or to a wing model in a wind tunnel, when the model extends right to the tunnel walls. Because of the absence of the spanwise flow induced by the presence of wingtips, no tip vortex and no variations in downwash behind the wing occur. A two-dimensional representation is all you need to depict what’s happening.

The streamlines generated by injecting smoke into a wind tunnel, or calculated in a computer simulation (Figure 3), allow us to visualize not just the direction of flow around a wing, but also its velocity and pressure. The flow direction at any instant or point along a streamline is always tangential to the line. An important feature of streamlines is that air particles never cross them; adjacent pairs of streamlines thus behave like the walls of a flexible tube. When the flow accelerates, the resulting decrease in static pressure within them causes the streamtubes to contract, and the streamlines move closer together. The distance between streamlines is thus an indication of relative velocity and static

pressure. Notice in the figure how the streamtubes passing over the leading edge contract, indicating an accelerating flow and a pressure decrease. As they move down the wing they expand, indicating a decelerating airflow and a pressure rise. This is shown in closer detail in Figure 5.

Note the upwash in the airflow ahead of the wing, and the downwash behind. In the two- dimensional case illustrated, the upwash and downwash angles are equal. In the three- dimensional case of a finite wing, the tip vortex can add significantly to the downwash behind the wing, as we’ll see later.

Upwash ahead of wing

Downwash behind wing

Streamlines move closer together as flow accelerates and static pressure decreases.

Figure 3 Streamlines Upwash/Downwash

Streamlines move apart as flow decelerates and static pressure increases.

Two-Dimensional Aerodynamics

Bill Crawford: WWW.FLIGHTLAB.NET2.4

Pressure Distribution

Figure 4 shows the surface pressure distribution along an airfoil section at three different angles of attack. The longer arrows represent increasingly higher or lower static pressures, as indicated, relative to the static pressure of the freestream, undisturbed air ahead of the section. The velocity over the forward, upper part of the wing increases as the angle of attack increases, resulting in a greater decrease in local static pressure, as well as a shifting of the pressure pattern. The illustrations show how the point of lowest static pressure (longest arrow) moves forward as angle of attack, α, increases.

Notice that at low α (as in the top illustration) the static pressure can drop below freestream under the wing as well as above. Lift results as long as the overall reduction in pressure above the wing is greater.

NACA 2412 4 Deg. Angle of Attack

NACA 2412 12 Deg. Angle of Attack

Decreased pressure

Decreased pressure

NACA 2412 0.3 Deg. Angle of Attack

Figure 4 Pressure Distribution versus Angle of Attack

Increased pressure

Two-Dimensional Aerodynamics

Bill Crawford: WWW.FLIGHTLAB.NET 2.5

Figure 5 illustrates streamlines and surface pressures together. Pressure is highest at the stagnation point (where it equals static plus dynamic pressure). Here airflow comes to a stop, and the streamlines split on either side to follow either the upper or lower surface. (Stagnation pressure is what the pitot tube senses. The static side of the pitot system eliminates the static component, and the remaining dynamic pressure appears as an airspeed indication.)

The low pressure generated by the acceleration of the flow over the leading edge creates a suction that draws the airflow forward from the stagnation point—against the general, leading-to- trailing-edge flow. Below stall, any increase in α further accelerates the upper-surface flow and further decreases th

*View more*